How to make header longer
You need: Giants Editor 4.1.2 or older version
Too wiev full image press on thumbail
1. First open it the i3d of the editing work that want to increase it, with the Giants Editor, I found the cutter7700.i3d (available at data/vehicles/cutters/fendt/fendtcutter7700.i3d.) Open it now. Should be something like this :
2. Now in the left side press on SideArms and in the right in scale x: write from 5 or bigger
3. Now do same with roll press on it and in the right side scale x: write 5 or bigger
4. Now do same with fendtcutter7700_vis press on it and in the right side scale x: write 5 or bigger
5. In the left side click on areaStart and move it to left side end. This is very important!!
6. Now do same but click on areaWidth and move it to right side end header, but not too much!!!
7. Finish. Its should be something like this. Have fun
You can do same with all headers for combines with Giants 4.1.2
December 23, 2009 at 5:45 pm |
can you also do that with tires
January 16, 2010 at 12:07 am |
i just tried that out
ok i did just a test with size 10
but now the header is white
how can i change skin size`?
if its possible
January 21, 2010 at 1:20 pm |
I tried it and it did work fine. the header was not white i did also trie a size 20 and that is something there goes fast
April 21, 2010 at 5:47 pm |
I’am having trouble making the header a little bit wider for the JD 9680 Hillmaster. Is there something different I should know.